Introduction
In this article we present to you the results of the
extreme endurance test that we have carried out in the previous days. This test
has been made on the purpose of stressing as much as possible our heat
exchangers and consequently to reach the mechanical limits of the special
weldless closing system. The maximum pressure that we have been able to obtain
was equal to 10Bar, since that was also the mechanical limit of the compressor
that we had in our disposition. The gauge of the waterblock, instead, has
recorded approximately 9.8Bar, since, most probably, it had a different
tolerance. Obviously we will try to do a new test with a higher pressure as soon
as it becomes possible.
Extreme test @ 10 Bar
By clicking on the following images you can see them
magnified.
NB To correctly visualize the films you need the
DivX 5.0.3 or superior.
Legal notice (translate from Italian
legal notice)
The present publication is merely indicative and is aiming
exclusively to a general understanding of the resistance of the weldless closing
system (proprietary technology); in no case should it be considered as a
representative proof of the product and/or the relative technology. The
administration of Overclock Labsฎ advices you against executing a test of this
kind, since it is highly dangerous, and it declines any liability, direct, civil
and/or penal, indirect and/or consequent. Anyone deciding to execute a similar
test will have to do it exclusivly on his own risk and danger.
